Route the cable, looping through the right side cable slots as shown in
9.
tight.)
Service Loop
Routing the Cable
Figure 3-22
NOTE The path through the cable slots is not intuitive. Send the cable towards the left of the tower (as shown)
even though the CSS module is on the right. (Take up all the slack outside the MP6000 chassis so the
CSS cable cannot be pinched by the checkstand.)
Connect the cable to the micro USB port at the bottom of the CSS scan module. Ensure the cable is
10.
clipped into the scan module plastic cable clip directly below the USB port.
Service
Loop
Connecting the Cable
Figure 3-23
SITE PREPARATION AND INSTALLATION 3 - 21
Cable Slots
Cable Slots
Scan Module Cable Clip
Micro USB Port
Figure
3-22. (Cable wire should be