Motorola MP6000 Integrator Manual page 176

5 - 22 MP6000 INTEGRATOR GUIDE
Beeper and LED Indicators (Continued)
Table 5-1
Condition Beeper Indication
EAS system None
functional (idle)
EAS tag detected Configurable: None,
anytime Geiger Counter clicks
EAS manual None
deactivation
activated
EAS Soft Tag None, Beep 1, Beep 2
Deactivation
EAS Hard Tag None, Beep 1, Beep 2
Detected
Firmware Download
Firmware Low, Medium, High
Download beep after complete
Parameter Programming
Parameter entry Low, High Beeps
error
Parameter High, Low Beeps
number entry
expected
Parameter entry High, Low, High, Low
accepted Beeps
Macro PDF
Macro PDF 2 Low Beeps
buffered
Macro PDF file ID 2 Long Low Beeps
error
System LED Button LED
Indication Indication
No change EAS LED is on
No change EAS LED blinks
yellow at 4 Hz
No change EAS LED on
No change No change
No change No change
Red alternating No change
between on and
fast blink
Red No change
Green No change
Green No change
No change No change
No change No change
Description
EAS is operating normally.
An EAS tag is in the EAS tag
detected area, and being detected.
When deactivation is active on the
system.
Beep indicates that a soft tag was
deactivated.
Beep indicates that a hard tag was
detected.
Firmware download in progress.
Firmware Download has multiple
states. The LEDs during these
states are:
•
During firmware data
download/transfer - no LED
control.
•
After reboot firmware is
installed: LED blinks red, fast.
•
After complete, normal power-up
beep.
Input error: incorrect bar code,
programming sequence, or Cancel
scanned.
Number expected. Enter value
using numeric bar codes.
Successful program exit with
change in parameter setting.
MDPF sequence buffered
File ID error. A bar code not in the
current MPDF sequence was
scanned.