Table of Contents
Advertisement
3 - 18 MP6000 INTEGRATOR GUIDE
After removing the tower cover, ensure the speaker wire ferrite is in the correct position, behind the tabs as
3.
shown in
Figure
is replaced.
Ferrite
tabs
Speaker Wire Ferrite Placement
Figure 3-17
Determine the side of the MP6000 to which the MX101 should be installed. The default is the customer's
4.
right side (the side of the MX101 tower cover already open for the scan module to be inserted).
NOTE See
Installing the MX101 on the Customer's Left Side of the Tower Cover on page 3-22
module on the customer's left side of the tower cover.
Remove the scan window cover from the CSS tower by squeezing the snaps shown below. The snaps are
5.
squeezed from inside the tower cover.
Snaps
Removing the Scan Window Cover
Figure 3-18
3-17. Failure to properly route the wire may cause the wire to pinch when the tower cover
to install the scan
Advertisement
Table of Contents
Troubleshooting
