Connecting An Fe Line To An Fe Wan Port - Cisco 800 Series Hardware Installation Manual

Cisco 860, 880, 890 Series
Connect the second unshielded Category 5 cable from the telecommunication service port on the splitter
Step 4
to the wall jack to allow a link to the network service provider.

Connecting an FE Line to an FE WAN Port

To connect the Fast Ethernet (FE) WAN port on the router, follow these steps:
Connect one end of the yellow cable to the FE WAN port as shown in
Step 1
Figure 3-26
WAN
FE 4
1
2
Connect the other end of cable to an available port on the modem.
Step 2
Cisco Integrated Services Router Hardware Installation Guide
3-30
Connecting the FE WAN Port
1
2
3
Internet Internet Internet
FE WAN port
CAT 5 cable
Chapter 3
Figure
1
3
Modem connected to the Internet
Connecting the Router
3-26.