Cisco 800 Series Hardware Installation Manual page 240

Cisco 860, 880, 890 Series
Caution Cisco Systems DSL WAN Interfaces are tested for compliance with regulatory standards such as FCC
Part 68, ITU-T K.21, IEC 61000-4-5, and CSA/EN/IEC/UL 60950-1. These standards assume Primary
Protection devices protect the Customer Premise Equipment (CPE). These devices are normally installed
by the service provider, local exchange carrier or qualified service person and are located at the telecom
service provider entrance, network interface box, or demarcation point. See
location of the primary protection device. The primary protection device must be suitable for the xDSL
interface employed. Please contact your sales team or qualified service person for further information
and installation.
To reduce the risk of fire, use only No. 26 AWG or larger (e.g., 24 AWG) UL Listed or CSA Certified
Caution
Telecommunication Line Cord.
Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry
Warning
tub, in a wet basement, or near a swimming pool. Statement 1035
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
Warning
risk of electric shock from lightning. Statement 1038
To report a gas leak, do not use a telephone in the vicinity of the leak. Statement 1039
Warning
Warning There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with
the same or equivalent type recommended by the manufacturer. Dispose of used batteries according
to the manufacturer's instructions. Statement 1015
Cisco Integrated Services Router Hardware Installation Guide
3-32
Chapter 3 Connecting the Router
Figure 3-28 for the likely