Cisco 800 Series Hardware Installation Manual page 241

Chapter 3 Connecting the Router
Figure 3-28
Note: Primary Protection
may be located Outside
or Inside of Premise
To connect the router to a global industry standard symmetrical high-speed DSL (G.SHDSL) line,
very-high-speed digital subscriber line 2 (VDSL2) port, or an ADSL2+ line, follow these steps:
Connect one end of an RJ-11 (RJ-45 on 880 E models) cable to the port on the router. See
Step 1
Figure 3-29
1
G.SHDSL port, VDSL2oPOTs port, or
ADSL2+ port
Connect the other end of the cable to the DSL wall jack.
Step 2
Primary Protection Device Location
Telecom Service
Home or Business
Router
* Alternative Underground Service Entrance
Building Ground Rod connected to
Service entrance and Primary Protection
Connecting the xDSL Line
1
2
Overhead Service
Entrance
Service Utilities Entrance
or Demarcation Point
Network Interface Box/
Network Interface Device/
Station Protector
2
DSL wall jack
Cisco Integrated Services Router Hardware Installation Guide
Cisco 860, 880, 890 Series
Figure 3-29.
3-33