Connecting An Adsl Line-Adslopots Port - Cisco 520 Hardware Installation Manual

Chapter 4 Router Installation
Connecting an ADSL Line—ADSLoPOTS Port
Turn on the broadband modem.
Step 3
Connecting an ADSL Line—ADSLoPOTS Port
This section applies only to the Cisco Secure Router 520 ADSL-over-POTS router.
Figure 4-7 shows the asymmetric digital subscriber line over plain old telephone service (ADSLoPOTS)
port on the router connected to an ADSL line.
The DSL line must have been provisioned by your service provider and correctly configured so that the
Note
ADSL CD LED shows the status. If the ADSL CD LED is not on, contact the DSL service provider.
Figure 4-7 Connecting the ADSLoPOTS Port to an ADSL Line
Cisco Secure Router 500 Series
1
2
1 2
ADSLoPOTS port on the router End of ADSL cable connects to the wall jack
Cisco Secure Router 520 Series Hardware Installation Guide
4-9
OL-12892-01