Cisco 800 Series Hardware Installation Manual page 231

Chapter 3 Connecting the Router
Figure 3-19
If you are using an extension cable, you must attach the 3G adapter for extended cable antenna to the
body of the router. Depending on the SKU ordered, the adapters come with different connectors.
Table 3-2
install the adapter, see the
page 3-24. Otherwise, follow
Table 3-2
3G Adapter SKU
3G-ACC-SMKTS9-TNC 3G adapter for extended cable/antenna
3G-ACC-SSMB-TNC
Step 7 Clean the flat surface to which you will affix the antenna.
Antenna with the SMK-TS- 9 Connector
SMK-TS-9
connector
lists the different adapters and SKUs supported by each adapter. For instructions on how to
"Installing the 3G Adapter for Extended Cable/Antenna" section on
Step 7.
3G Adapters and Supported SKUs
Description
with an SMK-TS-9 to TNC connector.
Use this with the pentaband dipole
indoor antenna
(3G-ANTM-SMKTS9).
3G adapter for extended cable/antenna
with an SSMB to TNC connector. Use
this with the pentaband dipole indoor
antenna shipped with your product.
Cable
Cisco Integrated Services Router Hardware Installation Guide
Cisco 860, 880, 890 Series
Original
antenna assembly
SKUs Supported
PCEX-3G-HSPA-R6,
CISCO881G-G-K9
PCEX-3G-HSPA,
PCEX-3G-HSPA-A,
PCEX-3G-CDMA-S,
PCEX-3G-CDMA-V,
PCEX-3G-CDMA-B,
CISCO881G-A-K9,
CISCO881G-S-K9,
CISCO881G-V-K9
3-23