Cisco 800 Series Hardware Installation Manual page 17

800 series integrated services router
Hide thumbs Also See for 800 Series:
Table of Contents

Advertisement

If the symbol of suitability with an overlaid cross appears above a port, you must not connect the port
Warning
to a public network that follows the European Union standards. Connecting the port to this type of
public network can cause severe personal injury or can damage the unit. Statement 1031
Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV)
Warning
requirements in IEC 60950 based safety standards. Statement 1033
Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry
Warning
tub, in a wet basement, or near a swimming pool. Statement 1035
Warning
Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations. Statement 1036
Warning
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface. Statement 1037
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
Warning
risk of electric shock from lightning. Statement 1038
When installing or replacing the unit, the ground connection must always be made first and
Warning
disconnected last. Statement 1046
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
Warning
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, because they may cause serious injury or death. For
proper installation and grounding of the antenna, please refer to national and local codes (for
example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code,
Section 54). Statement 1052
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Cisco Integrated Services Router Hardware Installation Guide
xv

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents