Installing The Router - Cisco 800 Series Hardware Installation Manual

Installing the Router

This chapter describes the equipment and the procedures for successfully installing the Cisco 860, 880,
890 ISRs, Cisco 819 ISRs, and the Cisco 812 ISRs, and contains the following sections:
•
•
Installing the Cisco 810 ISR
This section contains the following:
•
•
Installing the Cisco 812 ISR
This section describes the equipment and the procedures for successfully installing Cisco 812 ISR and
contains the following sections:
•
•
•
•
•
•
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Warning Voltages that present a shock hazard may exist on Power over Ethernet (PoE) circuits if
interconnections are made using uninsulated exposed metal contacts, conductors, or terminals.
Avoid using such interconnection methods, unless the exposed metal parts are located within a
restricted access location and users and service people who are authorized within the restricted
access location are made aware of the hazard. A restricted access area can be accessed only through
the use of a special tool, lock and key or other means of security. Statement 1072
Installing the Cisco 810 ISR, page 2-1
Installing the Cisco 860, 880, 890 ISR, page 2-38
Installing the Cisco 812 ISR, page 2-1
Installing the Cisco 819 ISR, page 2-19
Items Shipped with your Router, page 2-2
Items Shipped with your PoE+ Splitter, page 2-2
Installing the Cisco PoE+ Splitter, page 2-2
Installing the SIM Card, page 2-6
Installing the 3G Antenna, page 2-8
Mounting the Cisco 812 ISR, page 2-9
C H A P T E R
Cisco Integrated Services Router Hardware Installation Guide
2
2-1