Omron E5GN User Manual page 127

APPENDIX
Advanced function setting level
Protect level
Communications setting level
Communications setup on other party
personal computer is different.
A–12
Parameter initialize
Multi SP uses
SP ramp set value
Standby sequence reset method
Reset conditions after standby sequence
is canceled.
Alarm 1 open in alarm
Set the alarm output 1 ON/OFF states.
Alarm 1 hysteresis
ST stable range
Set the deviation.
Operation/adjustment protection
Restricts display and modification of menus
in the operation and adjustment levels.
Initial setting/communications protection
Restricts display and modification of menus
in the initial setup, operation level and adjust-
ment levels.
Setting change protection
Protects changes to setups by opera-
tion of the front panel keys.
Communication
unit No.
Baud rate
Data bit
Stop bit
Parity
α
Advanced PID parameter
MV upper limit
Limited to MV cal-
culation value
MV lower limit
Input digital filter
Set the time constant in seconds.
Additional PV display
Displayed first in the operation level.
Manipulated variable display
Automatic return of display mode
Automatic return to operation level when
the keys on the front panel are operated.
Move to calibration level
Alarm 1 latch
Protect level move time
Output input error
Cold junction compensation method
MB command logic switching