Omron E5GN User Manual page 85

CHAPTER 5 PARAMETERS
Initial Setting Level
Input type
• This parameter sets the sensor type by a corresponding code.
• When this parameter is changed, the set point upper limit is changed to the default.
If the set point limits must be changed, set the set point upper limit" and set point
Function
lower limit" parameters (initial setting level).
• Set the code according to the following table. Shaded ranges indicate default settings.
The defaults are as follows.
Platinum resistance thermometer:  ": platinum resistance thermometer Pt100
Setting
Thermocouple:  ": K thermocouple
Platinum resistance
thermometer
Thermocouple input
type
F Related parameters
_C/_F selection" Set point upper limit" Set point lower limit" (initial setting
level)
See
5–18
Input type Name
Platinum Pt100
resistance
thermometer thermometer
JPt100
Input type Name
Thermocouple K
J
T
E
L
U
N
R
S
B
Non-contact K10 to 70_C
temperature
K60 to 120_C
sensor sensor
ES1A
K115 to 165_C
K160 to 260_C
Analog input 0 to 50mV
Set
Input Temperature Range
Value
0 -200 to 850 (_C) / -300 to 1500 (_F)
1 -199.9 to 500.0 (_C) / -199.9 to 900.0 (_F)
2 0.0 to 100.0 (_C) / 0.0 to 210.0 (_F)
3 -199.9 to 500.0 (_C) / -199.9 to 900.0 (_F)
4 0.0 to 100.0 (_C) / 0.0 to 210.0 (_F)
Set
Input Temperature Range
Value
0 -200 to 1300 (_C) / -300 to 2300 (_F)
1 -20.0 to 500.0 (_C) / 0.0 to 900.0 (_F)
2 -100 to 850 (_C) / -100 to 1500 (_F)
3 -20 to 400.0 (_C) / 0.0 to 750.0 (_F)
4 -200 to 400 (_C) / -300 to 700 (_F)
5 0 to 600 (_C) / 0 to 1100 (_F)
6 -100 to 850 (_C) / -100 to 1500 (_F)
7 -200 to 400 (_C) / -300 to 700 (_F)
8 -200 to 1300 (_C) / -300 to 2300 (_F)
9 0 to 1700 (_C) / 0 to 3000 (_F)
10 0 to 1700 (_C) / 0 to 3000 (_F)
11 100 to 1800 (_C) / 300 to 3200 (_F)
12 0 to 90 (_C) / 0 to 190 (_F)
13 0 to 120 (_C) / 0 to 240 (_F)
14 0 to 165 (_C) / 0 to 320 (_F)
15 0 to 260 (_C) / 0 to 500 (_F)
16 One of following ranges depending on the
results of scaling:
-1999 to 9999, -199.9 to 999.9,