Initial Setting Level - Omron E5GN User Manual

This level is for setting up the basic specifications of the E5GN. In this level, you can set the
input type" parameter for selecting the sensor input to be connected to the E5GN, limit the set
ting range of set values or set the alarm mode.
Power ON
Operation Adjustment
level level
key
less than
1 sec.
key 3 seconds min.
key
1 second
min.
key
Control stops

Initial setting level

key
less than
1 sec.
To move from the operation level to the initial setting
level, press key for three seconds or more.
• The initial setting level is not displayed when ini
tial/communications protection" is set to 2". This
initial setting level can be used when initial setting/
communications protection" is set to 0" or 1".
• The scaling upper limit", scaling lower limit" and
decimal point" parameters are displayed when
analog input is selected as the input type.
The PV display flashes after one second
Commu-
nications
setup level
Control in progress
Control stopped

Initial Setting Level

Initial setting level
Input type
Scaling upper limit
Scaling lower limit
Decimal point
_C/_F selection
Set point upper limit
Set point lower limit
PID / ON/OFF
Standard/heating and
cooling
ST
Control period (OUT1)
Control period (OUT2)
Direct/reverse
operation
Alarm 1 type
Move to advanced
function setting level
Page
5-18
5-19
5-19
5-19
5-20
5-20
5-20
5-21
5-21
5-22
5-22
5-22
5-23
5-23
5–17