B Parameter Defaults, Setting Ranges, And Commands - Omron E5ZD Operation Manual

Parameter Defaults, Setting Ranges, and
This appendix provides a list of the commands according to the parameters or operations that they control. It also
provides the factory-set defaults, the number of digits required to set the parameter, and the parameter's setting
limits.
Where possible, commands are given in write-read pairs for the same parameter or operation. The "Write code" is
the header code used to write the parameter or operation; the "Read code" is the header code used to read the
parameter or status. If the same header code is used for more than one command, the data code is provided with it.
Refer to the body of this manual for details.
Commands Controlling Operation
Command Write code
Operation Start OS
Operation Stop OP
Autotuning Start AS
Autotuning Stop AP
Commands for Parameters Independent of Control Points
Parameter
HB/HS Alarm Point
Output Mode
Commands for Parameters for Individual Control Points
Parameter
Memory Bank
Designation
Alarm Modes 1 and 2
Detection Level
Commands Controlling Operations
Command
Initialize Parameters
Transmission Test
Undefined Error
EEPROM Write
Appendix B
Commands
Read code
RX-02
RX-02
RX-02
RX-02
Write code Read code
WU-02 RU-02
WU-00 RU-00
Write code Read code
WM RM
W# R#
WW RW
Header code Digits
MC 0
TS 118
IC NA
WE NA
Digits
0
0
0
0
Digits Default
4 0000
4 0000
Digits Default
4 0000
4 0000
4 0000
---
---
Returned in response for unrecognizable command
Writes RAM contents to EEPROM
Upper Lower
0000 00FF
0000 00FF
Upper Lower
0000 0007
0000 000C
0000 0500
Remarks
Remarks
Bit data
Bit data
Remarks
---
---
0.1 A unit
133