Eaton Powerware 5125 Installation Manual page 13

10. Slide the UPS and any optional EBMs into the rack.
11. Secure the front of the cabinets to the rack using two pan-head
screws on each side (see Figure 10).
12. Loosen the wing nut on each rear hold-down bracket and slide the
bracket over the rear of the cabinet. Tighten the wing nut.
13. Tighten the pan-head screws that secure both rails to the front of
the rack (see Step 3 on page 6).
14. Continue to the following section, "EBM Installation," or "UPS
Installation" on page 11.
®
EATON Powerware 5125 (9910-E33) UPS Installation Guide for IBM
Figure 10. Securing the Front of the Cabinet
Rear Hold-Down Bracket
UPS Rear Panel
(panels may vary)
Figure 11. Securing the Back of the Cabinet
®
Applications
INSTALLATION
Position 6
Position 1
S 9
164201695 Rev 1