Onboard Device; Usb Controller - Albatron PX865PE PRO II User Manual

IDE Primary/Secondary/Master/Slave
The IDE PIO (Programmed Input / Output) fields let yo
devices that the onboard IDE interface supports. Modes 0 to 4 will increase performance
increm entally. In Auto mode, the system automatically determines the best mode for each device.
O ptions: Auto (default)、Mode0、Mode1、Mode2、Mode3、Mode4.
ID E Primary / Secondary /Master / Slave UDMA
U ltra DMA 100 functionality can be implemented if it is supported by the IDE hard drives in your
sy stem. As well, your operating environment requires a DMA driver (Windows 95 OSR2 or a third
p arty IDE bus master driver). If your hard drive and your system software both support Ultra DMA
1 00, select "Auto" to enable BIOS support. Options: Auto (default)、Disabled
* **OnChip Serial ATA Setting***
SA TA Mode
W hen the "On-Chip Serial ATA" set to the "Combined Mode" and this item will allowsyou to select
th e SATA Mode. Options: IDE (default)、RAID
On-Chip Serial ATA
This item allows you to enable or disabled the on-chip serial ATA function.
Options: Disabled (default)、Auto、Combined Mode、Enhan
Serial ATA Port0 / 1 Mode
This item allows you to select the Serial ATA device mode for port 0 & 1.
Options: Primary Master、Primary Slave、Secondary Master、Secondary Slave

Onboard Device

If you highlight the "INTEL OnCh
to a submenu with the following options:

USB Controller

This option should be enabled if your system has a USB port installed on the system board. You will
need to disable this feature if you add a
O ptions: Enabled (default)、Disabled
USB 2.0 Controller
This option should be enabled if your system has a USB 2.0 device installed on the system board.
You will need to disable this feature if you install a USB 1.1 device.
O ptions: Enabled (default)、Dis
PIO
u set a PIO mode (0-4) for each of the IDE
ip PCI Device" label and then press the enter key, it will take you
higher performance controller.
abled
36
PX865PE PRO II
ced Mode、SATA Only