Connectors; Sata1 Sata2 - Albatron PX865PE PRO II User Manual

Con nectors
Flop py isk Con D
This mainboard provides a sta
1.44M and 2.88 M floppy diskettes.
in the p acka ging.
Hard Disk Connectors: IDE1-2/ RAID IDE1-2/ SATA1-2
This mainboard has a 32-bit Enhanced PCI IDE Controller
Ultra ATA 66/ 100. This mainboard provides two
(secondary). It also has a Serial ATA controller and provides two serial ATA connectors. This
mainboard also comes with a PROMISE PDC20276 chip that supports two RAID IDE connectors.
IDE1 (Primary IDE
You can connect up to two hard drives to IDE1. If you attach two drives, you must use a ribbon cable
with three connectors. You must also configure one drive as the master and one drive as the slave,
using the jumpers located on each drive.
IDE2 (Secondary IDE Connector)
The IDE2 connector can also support a Master and a Slave drive. The configuration is similar to
IDE1. The second drive on this controller must
RAID IDE1/ RAID IDE2
These RAID connectors provide support for Ultra ATA 133 and RAID specifications 0 or 1. These
connectors can only connect to 1 master device each and is not capable of supporting slave devices.
SATA1/ SATA2
These SATA connectors support Serial ATA 150
can connect to one serial ATA hard disk each. (For more details please refer Appendix III.)
RAID IDE1
RAID IDE2
ne ctor: FD C
ndard floppy disk c onn tor (FDC) that su
This connector supports the floppy driv
Connector)
be set to slave mode.
and SATA RAID 0 mode. These connectors only
SATA1 SATA2
14
PX865PE PRO II
ec pports
e ribb
that supports PIO Mode 0~4, Bus Master,
IDE connectors, IDE1 (primary) and IDE2
FDC
IDE2
IDE1
360K, 720K, 1.2M,
on cables provided