Front Panel Indicator: Sw/Led、Jp2 - Albatron PX865PE PRO II User Manual

F ront Panel Indicator: SW/LED、JP2
The SW/LED and JP2 headers are used to attach to indicators o
-
JP2
+ 1
-
3
-
5
+
7
9
SW/LE
Pin Assignment Function Pin Assignment Function
1
HD LED
3
HD LED (-)
5
Reset Control (-)
7
Reset Control(+)
9
NC
HD LED (Hard Drive LED Connector)
This connector can be attached to an LED on the front panel of a computer case. The LED will
flicker during disk activity. This disk activity only applies to those IDE drives directl
system board.
RST (Reset Button)
This connector can be attached to a momentary SPST switch. This switc
When closed it will cause the mainboard to reset and run the POST (Power On S
PWR-LED (2-pin Pow
The mainboard pro vides two power LED connector.If there is a 2-pin power
panel of a computer case. You can attach it to the 2-pin power LED
illuminate while the computer is powered on.
PWR ON (Pow er Button)
This connector can be attached to a front panel power switch. The
pin to ground fo r at least 50 ms to signal the power supply to switch on or off
due to internal deb ounce circuitry on the system board). At least two seconds
power supply will r ecognize another on/off signal.
JP2 (3-Pin Power LED Connector)
The mainboard provides two power LED connector. If there is a 3-pin power LED cable on the front
panel of a computer case. You can attach it to the 3-pin power LED connector.
NC
+
1
2 +
-
4
6 +
-
8
10
D
2
(+) Hard Drive
4
LED
6
Reset
8
Button
10
NC
er LED Connector)
13
PX865PE PRO II
n the front panel of your computer.
Power LED (+) POWER
Power LED (-) LED
Power Button(+) Power-on
Power Button(-) Button
NC NC
h is normally left open.
elf Test).
LED cable on the front
connector. The LED will
switch must pull the Power Button
(the time required is
must pass before the
y attached to the