Super Io Device; Onboard Fdc Controller; Onboard Serial Port 1; Onboard Serial Port 2 - Albatron KX600 PRO User Manual

KX600 Series Mainboard
USB 2.0 Controller
This option should be enabled if your system has a USB 2.0 device installed on the system board.
You will need to disable this feature if you install a USB 1.1 device.
Options: Enabled (default)、Disabled
UBS 2.0 Driving
This item allows you to control the transmission single to drive the USB 2.0 devices.
Options: The range is 00-FF, and the default is 11.
USB Device Support
Enables support for USB attached devices. Options: Disabled (default)、Enabled

Super IO Device

If you highlight the literal "Press Enter" next to the "Super IO Device" label and then press the enter
key, it will take you a submenu with the following options:

Onboard FDC Controller

Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and
you wish to use it. If you install an add-in FDC or the system has no floppy drive, select "Disabled"
in this field. Options: Enabled (default)、Disabled

Onboard Serial Port 1

Select an address and corresponding interrupt for the first serial port.
Options: Disabled、 3F8/IRQ4 (default)、 2F8/IRQ3、 3E8/IRQ4、 2E8/IRQ3、 Auto

Onboard Serial Port 2

Select an address and corresponding interrupt for the second serial port.
Options: Disabled、2F8/IRQ3 (default)、3F8/IRQ4、3E8/IRQ4、2E8/IRQ3、Auto.

Onboard Parallel Port

This item allows you to determine the parallel port interrupt and address.
Options: 378/IRQ7 (default)、278/IRQ5、3BC/IRQ7、Disabled
36