Ricoh S-C4.5 Field Service Manual page 363

Power failure report
5
0: Disabled 1: Enabled
Conditions for printing the protocol
dump list
6 0: Print for all communications
1: Print only when there is a
communication error
Priority given to various types of
remote terminal ID when printing
reports
7 0: RTI > CSI > Dial label > Tel.
Number
1: Dial label > Tel. number > RTI >
CSI
System Switch 0A [SP No. 1-101-011]
No FUNCTION
0-3 Not used
4 Dialing on the ten-key pad
when the external telephone is
off-hook
0: Disabled 1: Enabled
5 On hook dial
0: Disabled 1: Enabled
6-7 Not used
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
1: A power failure report will be automatically printed after
the power is switched on if a fax message disappeared from
the memory when the power was turned off last.
This switch becomes effective only when system switch 00
bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol dump
list only for communications with errors.
This bit determines which set of priorities the machine uses
when listing remote terminal names on reports.
Dial Label: The name stored, by the user, for the Quick/
Speed Dial number.
COMMENTS
Do not change these settings.
0: Prevents dialing from the ten-key pad while the external
telephone is off-hook. Use this setting when the external
telephone is not by the machine, or if a wireless telephone
is connected as an external telephone.
1: The user can dial on the machine's ten-key pad when
the handset is off-hook.
0: On hook dial is disabled.
Do not change the factory settings.
Bit Switches
5
167