Ricoh S-C4.5 Field Service Manual page 236

3. Appendix: SP Mode Tables
5120* Clr For Cut Remove
Specifies the condition to reset the copy job settings when the key counter is removed.
• 0: Y = Yes: The settings are cleared when the counter is removed.
• 1: StdBy = Standby only: The settings are cleared when the counter is removed at the
5120 1
• 2: N = No: The settings are not cleared under either condition.
As for duplex copying, the job settings are always preserved regardless of these setting.
3
5121* Counter Up Timing
Selects the count-up timing.
5121 1 • 0 = Feed: At each paper feed
• 1= Exit: At each paper exit
Fax Prnt Cnt Off
5167
Enables or disables the automatic print out without an accounting device. This SP is used
when the receiving fax is accounted by an external accounting device.
001 Fax Prnt Cnt Off
CE Login
5169
If you change the printer bit switches, you must 'log in' to service mode with this SP before
you go into the printer SP mode.
001 CE Login
5188 Copy NV Version
001 Copy NV Version
40
[0=Yes / 1=Standby only / 2=No]
end of a job.
[0 = Feed In / 1 = Exit]
CTL
CTL
CTL
[ 0 or 1 / 0 / – ]
0: Automatic printing
1: No automatic printing
[0 or 1 / 0 / - ]
0: Disabled
1: Enabled
Displays the NVRAM version in the controller board.