Ricoh S-C4.5 Field Service Manual page 251

002 CE Call
003 Function Flag
007 SSL Disable
008 RCG Connect T/O
009 RCG Write Timeout
010 RCG Read Timeout
011 Port 80
013 RFU Timing
Performs the CE Call at the start or end of the service.
[0 or 1 / 0 / 1 /step]
0: Start of the service, 1: End of the service
• This SP is activated only when SP 5816-001 is set to
"2".
Enables or disables the remote service function.
[0 or 1 / 0 / 1 /step]
0: Disabled, 1: Enabled
Uses or does not use the RCG certification by SSL when
calling the RCG.
[0 or 1 / 0 / 1 /step]
0: Uses the RCG certification
1: Does no use the RCG certification
Specifies the connect timeout interval when calling the RCG.
[1 to 90 / 10 / 1 second/step]
Specifies the write timeout interval when calling the RCG.
[1 to 100 / 60 / 1 second/step]
Specifies the read timeout interval when calling the RCG.
[1 to 100 / 60 / 1 second/step]
Enables/disables access via port 80 to the SOAP method.
[0 or 1 / 0 / – ]
0: Disabled, 1: Enabled
Selects the timing for the remote firmware updating.
[0 or 1 / 0 / – ]
0: Any status of a target machine
1: Sleep or panel off mode only
System Service Mode
3
55