Figure 28— Installing the Rotor and Bearing
Assembly — V-Groove Type
1. The coil, pulley rim and the rotor and bearing assem
bly (figure 28).
2. Loctite 601 or equivalent on the rim screw threads.
3. Screws. Do not tighten.
4. The assembly on the front head.
• Make sure the clutch coil term inals are aligned
correctly.
R-4 AIR CONDITIONING COMPRESSOR 1B 3 -1 1
5. Clutch coil assem bly using J 26271-A and J 29886
6. Retaining ring.
POLY-GROOVE DRIVE
1. The coil assembly on the front head neck.
2. Rotor and bearing assembly on the front head.
3. Clutch coil assem bly using J 26271-A and J 29886
4. Retaining ring.
+ « - Install or Connect (Figures 31, 32 and 33)
26271 -A
Figure 29— Installing the Rotor and Bearing
Assembly — Poly-Groove Type
• Make sure the protrusions on the rear of the coil
align with the front head locator holes.
(figure 29).
Install or Connect (Figure 30)
Tools Required:
J 26271-A Rotor and Bearing Installer
J 29886 Driver Handle
• Align the marks made at disassembly.
• Make sure the clutch coil term inals are aligned
correctly.
• Make sure the protrusions on the rear of the coil
align with the front head locator holes.
(figure 29).
6 POLE CLUTCH AND/OR
BEARING
Tools Required:
J 6083 Snap Ring Pliers
J 9481-A Pulley and Bearing Installer
F-06144