1B4-6 HR-6 AIR CONDITIONING COMPRESSOR
A. S ta k in g Pin
B. R u b b e r Band
Figure 14 — Staking the Pulley Bearing in the
Rotor Bore
Figure 15 — Staking Locations
• Strike the staking pin with a ham mer until a
metal stake, similar to the original, is formed
down to, but not touching the bearing.
—
Position the stake pin after striking.
—
The staked metal should not contact the
outer race of the bearing to prevent the
possibility of bending the outer race.
—
Stake 3 places 120 degrees apart (figure
15).
3.
Pulley (5) on the front head.
• Position J 33017 and J 33023-A over the inner
race of the bearing (figure 16).
• Position J 8433-1 on J 33023-A and assemble
the through bolts and washers through the pul
ler bar slots and thread them into J 33026 (fig
ure 16).
B-06544
A. S take Three
(3) L o c a tio n s
120° A p art
B-06546