Table of Contents
Advertisement
È Fasten the TPS lead (in the
sub wire harness) under the
frame so that it does not con-
tact the carburetor.
Ô Make sure that the TPS lead
coupler does not go outside the
chassis.
Fasten the TPS lead under the
coupler to the frame with a
plastic locking tie.
Ò Pass the carburetor breather
hose
and
overflow
between the connecting rod
and cross tube (frame).
˜ Fasten the neutral switch lead
and oil hose together with a
plastic locking tie and cut off
the tie end.
CABLE ROUTING DIAGRAM
ˆ Fasten
the
breather hose with the hose
holder.
Ø Fasten the neutral switch lead
to the frame with a plastic band
ends toward the rear of the
frame.
∏ Fasten
the
breather hose with the hose
holder.
ΠPass the clutch cable through
hose
the cable guide.
 Fasten the neutral switch lead
and CDI magneto lead together
with a plastic band.
Í Pass the clutch cable on the
inside
the
breather hose.
cylinder
head
cylinder
head
cylinder
head
2 - 22
SPEC
Ê Pass
the
cylinder
breather hose along the inner
side of the radiator pipe.
Ë Pass the radiator breather
hose from the right side of the
frame to the left side, over radi-
ator pipe 1, along the inner side
of radiator hose 4 and the radi-
ator, and between the lower
engine bracket, crankcase, oil
hose and the frame.
◊ Pass the clutch cable between
the frame and radiator and
over the lower boss on the radi-
ator.
head
Advertisement
Table of Contents
