Table of Contents
Advertisement
EC240000
CABLE ROUTING DIAGRAM
1 Hose guide
2 Brake hose
3 Fuel tank breather hose
4 Oil tank breather hose
5 Clamp
6 Sub wire harness
7 TPS (throttle position
sensor) lead
8 Neutral switch lead
9 Oil hose
0 Hose holder
A CDI magneto lead
B Clutch cable
C Cylinder head breather hose
D Carburetor breather hose
E Overflow hose
CABLE ROUTING DIAGRAM
Å Pass the clutch cable through
the cable guide.
ı Pass the fuel tank breather hose
between the handlebar and ten-
sion bar, then insert its end into
the hole of the number plate.
Ç Pass the decompression cable
under the oil tank breather pipe.
Î Fasten the CDI magneto lead
and neutral switch lead to the
frame with a plastic locking tie
and cut off the tie end.
‰ Fasten the sub wire harness to
the frame at the white tape for
the sub wire harness with a
plastic locking tie and cut off the
tie end.
2 - 21
SPEC
Ï Pass the cylinder head breather
hose along the right side of the
oil tank breather hose.
Ì Fasten the sub wire harness to
the frame with a plastic locking
tie ends at the lower left of the
frame and cut off the tie end. For
fastening, pass the plastic lock-
ing tie through the upper holes
in the engine brackets.
Ó Pass the sub wire harness
between the engine brackets.
Advertisement
Table of Contents
