Preparing A Disk Array For Transport; Rebuilding A Disk Array - G-Technology G Speed studio Product Manual

Preparing a Disk Array for Transport

This feature prepares the physical drives that make up the disk array to be removed from
the enclosure and installed in a different G-SPEED Studio R enclosure. To prepare a disk
array for transport:
1. Perform one of the following actions:
• From the Dashboard window, click the Disk Array link.
• From the Storage menu, choose Disk Array.
2. Mouse-over the disk array you want, then click the Transport button.
3. In the Confirmation box, type the word "CONFIRM" in the field provided, then click the
Confirm button. The disk array status will change to Transport Ready.
4. Remove the physical drives and install them in their new location.
See Replacing a Physical Drive for more information.

Rebuilding a Disk Array

When you rebuild a disk array, you actually rebuild data on one physical drive from
redundant data maintained on other drives. If there is no spare drive of adequate capacity,
you must replace the failed drive with an unconfigured physical drive, then perform a
Manual Rebuild.
On the carrier with the failed drive, the drive power/ status LED will be red.
Drive carrier LEDs for a dead or failed drive:
Configuring G-SPEED Studio R
Red LED
p. 76