Cleaning The Optical System - Elation PowerSpot 575IE User Manual

Power Spot 575IE™
Attention:
1. Never allow optical parts to come in contact with oil, dirt, or grime.
2. Allow all parts to dry completely before attempt operation.
3. Never clean the aspheric lens with water or other cleaners. The lens
should be changed at the first sign of ware, usually in about 1 – 2 years
(lens will begin to look cloudy). For lens replacement please contact
Elation technical support.
9.3

Cleaning the Optical System

technicians only)
9.3.1 Always disconnect main power before attempting any service related issues!
9.3.2 Allow ample time for the lamp to cool (at least 20 minutes) before performing any
cleaning procedures.
9.3.3 Open and remove the upper half of the projector by loosening the 4 retaining
Phillips screws. Two located on the front and 2 located on the rear of the head.
9.3.4 Follow the chart above to complete the service procedures.
9.3.5 Replace the shell and tighten the 4 retaining screws.
9.3.6 Be sure the cover has been replaced and all the parts have completely dried
before attempting operation.
©Elation Professionals® Los Angeles, Ca.
(recommended for qualified service
- wwww.ElationLighting.com
40
- Page