Master-Slave - Elation PowerSpot 575IE User Manual

Power Spot 575IE™
switched "OFF."
4.2.5 Choose your room size. The size function allows you to choose a the approximate
size of the room (NORM, BIG, MIDL, SMAL). The built-in programs will
automatically adjust to your slection to optimize light output for your room.
4.2.6 Use the sound sensitivity knob on the side control panel to make the unit more or
less sensative to sound. Turning the knob in clockwise direction will make the unit
more sensetive to sound, while turning the knob counter-clockwise will make the unit
less sensetive to sound. Note: This unit will react to the low frequiencies of a sound
source, tapping on the fixture or high pitched sound may not trigger the fixture.
4.3 Master-Slave Operation (Sound Active): This function will allow you to link up to 16
fixtures together and operate without a controller. The fixtures will be sound activated. In
Master-Slave operation one fixture will act as the controlling fixture and the others will
react to the controlling fixtures programs. Any fixture can act as a Master or as a Slave.
4.3.1 Using standard XLR microphone cables, daisy chain your fixtures together via the
XLR connector on the rear of the fixtures. Remember the Male XLR connector is the
input and the Female XLR connector is the output. The first fixture in the chain
(master) will use the female XLR connector only - The last fixture in the chain will use
the male XLR connector only. For longer cable runs we suggest a terminator at the
last fixture.
4.3.2 Follow the same procedures listed in the previous Stand-Alone section. With two
exceptions; Be sure the first unit in the chain is selected as the "master" (
turned on in the audio submenu. All other fixtures must be in "slave" mode (
turned on in the audio submenu.
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com
MSTR
) is
SVPT
)
27
- Page