Setting The Dmx - Address - Elation PowerSpot 575IE User Manual

Power Spot 575IE™
DFSE
FEED
EFLG
3.1 Setting/Changing the DMX Address
After applying power to the POWER SPOT 575IE™ the LED will display the fixture's
current DMX address immediately after the reset sequence. If the fixture is not receiving
a DMX signal the display will flash continuously.
D001
To set or adjust a DMX address, please follow the procedure below:
1. Switch on the POWER SPOT 575IE™ and wait for the fixture reset process to
RESE
finished ('
2. Press the Mode button to access the main menu. Toggle through the menu b y
pressing the Up and Down buttons until the display shows
button to make changes to the address, the current three digit address will
immediately begin to flash.
3. While the current three-digit address is flashing, use the Up and Down buttons to
select adjust the address. Lock your new address into the unit's memory by pressing
the Enter button. After the new address has been successfully stored into the
fixture's memory the LED will briefly readout
The DMX address is non-destructible and will remain in the fixture's memory even when
the power has been switched off. Memory is backed-up and retained by an internal
power source with a five year shelf life.
3.2 Test Program
Test
The Test Program engages the fixture's internal test mode. This function runs a
complete test procedure of all functions. Press Enter to launch the self-test or the Mode
button to cancel and return to the main menu.
©Elation Professionals® Los Angeles, Ca.
VTR1 Software version, driver board 1
VTR2 Software version, driver board 2
VTR3 Software version, driver board 3
Call on the default function values
Pan/Tilt feedback (error correction) On/Off
Correction of faults
' will flash in the LED while fixture is in reset mode).
-
OK
.
wwww.ElationLighting.com
D001
. Tap the enter
17
- Page