Safety Regulations - Elation PowerSpot 575IE User Manual

Power Spot 575IE™
8. Changing/Replacing Gobos
The POWER SPOT 575IE™ is fitted with a standard size gobo wheel that accepts gobos
with an outside diameter of 27mm and a viewable image size of 23mm. Glass or steel gobos
may be used. Please follow the safety procedures and installation below for proper and pain
gobo exchange. Please refer to the specification section at the end of this manual
for exact gobo specifications!

Safety Regulations

• Always disconnect the main power supply!
• If the unit was recently in operation, be sure to allow the unit a minimum of 20 minutes
to cool before opening the unit.
• To avoid eye injury and reduce exposure to UV radiation always be sure to replace
the protective outside casing before attempting operation.
8.1 Installing/Replacing Gobos
8.1.1 Always be sure to disconnect the main power supply before attempting any
service.
8.1.2 Remove the upper shell of the protective cover by removing the 4 retaining
Phillips screws, 2 located on the front and 2 located on the rear of the head.
8.1.3 Once the outer cover has been removed;
a) Fixed Gobo Wheel; Rotate the gobo wheel to a position that allows easy
access to the gobo you want to replace. Using a small flat-head screwdriver,
gently pry out the gobo retaining spring.
b) Rotating Gobo Wheel; The rotaing gobo wheel uses a unique quck-change
system. To remove a gobo, genetly pull up on the gobo holder and pull out.
Refer to the illustration below
8.1.4 Replace the gobo and reinsert the retaining spring to secure the new gobo in
place. Be sure the retaining spring is insert properly to avoid damage to the wheel.
8.1.5 Reassemble the POWER SPOT 575IE™ in reverse order.
Special Notice:
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com
37
- Page