Yealink SIP-T23P User Manual page 26

User Guide for the SIP-T23/T23P/T23G IP Phone
If you are using an xDSL modem for IPv4 network connection, you can connect your
phone to the Internet via PPPoE mode. Set the WAN port as a PPPoE port. The PPPoE port
will perform a PPP negotiation to obtain the IP address. Contact your system
administrator for the PPPoE user name and password.
To configure PPPoE via phone user interface:
1. Press Menu->Settings->Advanced Settings (default password: admin)
->Network->WAN Port.
2. Press
3. Press
4. Enter the user name and password in the corresponding fields.
5. Press the Save soft key to accept the change or the Back soft key to cancel.
Note
Wrong network settings may result in inaccessibility of your phone and may also have an
impact on your network performance. For more information on these parameters,
contact your system administrator.
Generally, your phone will be deployed with multiple other phones. In this case, your
system administrator will configure the phone parameters beforehand, so that after you
start up your phone, the phone will be registered and ready for use. If your phone is not
registered, you may have to register it. For more information on how to register your
phone, refer to
If the phone has successfully started up, the idle screen will be displayed as below:
The idle screen displays the label of current account, time and date, and four soft keys.
16
to select IPv4 and press the Enter soft key.
to select PPPoE IP Client and press the Enter soft key.
Account Management on page 57.