Yealink SIP-T23P User Manual page 102

User Guide for the SIP-T23/T23P/T23G IP Phone
8. Repeat steps 5 to 7 until you have added all intended parties.
The procedures to set up a network conference call for specific servers may be different
from introduced above. Contact your system administrator for more information.
You can use call park to place a call on hold, and then retrieve the call from another
phone in the system (for example, a phone in another office or conference room). You
can park an active call by pressing the call park key on the phone. If the call is parked
successfully, the response is either a voice prompt confirming that the call was parked,
or a visible prompt on the LCD screen.
Note
Call park is not available on all servers. Contact your system administrator for more
information.
To configure a call park key via phone user interface:
1. Press Menu->Features->DSS Keys.
2. Press
3. Press
4. Press
5. Press
Account ID field.
6. (Optional.) Enter the string that will appear on the LCD screen in the Label field.
7. Enter the call park code in the Value field.
8. Press the Save soft key to accept the change or the Back soft key to cancel.
Call park key is configurable via web user interface at the path DSSKey->Line Key.
To use call park:
1. User on phone A places a call to phone B.
2. User on phone A wants to take the call in a conference room for privacy, and so
presses the call park key on phone A.
3. User on phone A walks to an available conference room where the phone is
designated as phone C. The user dials the call park retrieve code to retrieve the
92
or to select the desired DSS key, then press the Enter soft key
or , or the Switch soft key to select Key Event from the Type field.
or , or the Switch soft key to select Call Park from the Key Type field.
or , or the Switch soft key to select the desired account from the