Programming Channel Memory; Auto Program - ProScan Monitor/Receiver Owner's Manual

Programming Channel Memory

The quickest way to program the Channel Memory is
to use the function. Your TV
AUTOPROGRAM
automatically cycles through and places active
channels into Channel Memory.
Follow the instructions below to autoprogram channels,
then add or erase individual channels as desired.
AutoProgramming Channels into Channel Memory
with or without remote
1 Connect home antenna(s) or cable-TV to your set.
2 Repeatedly press the
button to select
MENU
and press + to display the setup functions.
Mute
Video Menu
Audio Menu
Setup Menu
3 Repeatedly press the
button until the
MENU
menu is selected.
Set Alarm
Chan Label
Parental Ctrl: Off
Chan Ctrl: Normal
Autoprogram
4 Press either + or – to begin programming. The TV will
cycle thru available channels in your area and place active
channels into memory.
10:44 18
Set Alarm
Chan Label
Parental Ctrl: Off
Chan Ctrl: Normal
Autoprogramming
The TV first programs all channels for
then all channels for
input connected).
10:44
Set Alarm
Chan Label
Parental Ctrl: Off
Chan Ctrl: Normal
Autoprogramming
5 When the TV finishes cycling, you can check which
SETUP MENU
channels are in memory by pressing the
down button. Your set will stop on each of the channels in
memory.
Your TV will remember which channels are in memory
until you erase them or until you autoprogram channels
again. Extended power failures have no effect on the
channel memory.
AUTOPROGRAM
input and
ANT A
input (even with one antenna
ANT B
18 10:46
Set Alarm
Chan Label
Parental Ctrl: Off
Chan Ctrl: Normal
Autoprogramming
up or
CHANNEL
17
21