Alarm On/Off - ProScan Monitor/Receiver Owner's Manual

T r o u b l e C h e c k s
Troubles sometimes are caused by simple "faults" that you
can easily correct without the help of a service technician by
first checking a few basic remedies.
Before you call or take your unit to an Authorized ProScan
TV Servicenter, look below for the type of trouble you are
experiencing. Then perform the simple checks and
adjustments listed for that trouble.
TV will not turn on
• Check to make sure it is plugged in.
• Check the wall receptacle (or extension cord) to make sure
it is "live" by plugging in something else.
• Maybe batteries in remote control are "dead".
• Maybe remote control is not aimed at remote sensor.
• Make sure power cord is fully inserted into back of TV.
Controls don't work
• If using remote control, make sure remote is in "TV Mode"
by first pressing button.
TV
• Try unplugging set for two minutes and then turning it on
again.
• Make sure power cord is fully inserted into back of TV.
Intermittent or no remote
• Maybe something is between the remote and the remote
sensor.
• Maybe the remote is not aimed directly at the component
(TV or VCR) you are trying to control.
• Maybe remote is not in "TV Mode". Press the
remote will control TV.
• Maybe batteries in remote are weak or dead or installed
incorrectly. Try replacing batteries.
• Remove batteries and hold down one or more buttons for
several seconds. Install the batteries and try remote
Turns off while playing
•
function may have been activated.
SLEEP TIMER
• function may have been activated.
ALARM OFF
50
• Electronic protection circuit may have been activated
because of a power surge. Wait 30 seconds and then turn on
again. If this happens frequently, the voltage in your house
may be abnormally high.
• Make sure power cord is fully inserted into back of TV.
Turns on unexpectedly
•
ALARM ON
does not turn off TV at correct time
ALARM
• Check

ALARM ON/OFF

• Check to make sure
time.
Blank screen
• Maybe Channel 90, 91, or 92 is selected, but device
connected to those
• Try another channel.
No sound, picture okay
• Maybe sound is muted. Try pressing
restore sound.
• Maybe TV's speakers are turned off. Check
function.
ON/OFF
• If using channel 90 (
component, remember to also connect the component's
and
R AUDIO OUT
• Maybe
SPEAKER
button so
TV
position.
Can't select certain channel
• Channel may not be in Channel Memory. Try pressing two
number buttons.
• If using a VCR, check to make sure the
VCR is in the correct position.
• To select cable channels 100 through 128, press number
button 1 until 1– – appears. Then press the other two
number buttons. The
mode to select channels higher than 69.
function may have been activated.
function. Must be set to
function is set to the correct
CLOCK
jacks is not turned on.
INPUT
VOLUME
input) with an S-VHS
S-VIDEO
jacks to the TV's and
L
switch on back of TV is not in the
function must be in
CABLE/AIR
ON.
up button to
SPEAKERS
L
jacks.
R INPUT 1
INTERNAL
switch on the
TV/VCR
CABLE