Video Out; Video Input - ProScan Monitor/Receiver Owner's Manual

R i g h t P a g e T e x t
Noisy stereo reception
• May be a weak station. Use
function to mode instead of
MONO
No picture, no sound but power light is on
• Maybe someone changed
CABLE/AIR
• Maybe a vacant channel is tuned.
• For Channels 90, 91, and 92, make sure the component
connected to those jacks is turned on in order to see
INPUT
picture.
• If watching VCR (connected only through antenna input),
make sure TV is tuned to channel 3 or 4 – same as
switch on VCR. Also check to make sure
VCR is in correct position.
Sound okay, picture poor
• Check antenna connections.
• Try adjusting function to improve weak signals.
SHARPNESS
Can't get two channels for picture-in-picture
• One channel must come through
other channel must come through the
• If using the or button, make sure it is programmed
VCR1 VCR2•LD
to select the proper video input channel as described on page
24.
• Check position of switch on VCR.
TV/VCR
• If using an S-VHS component, make sure its regular
is connected to
INPUT 1 VIDEO
No picture while using picture-in-picture, with S-VHS VCR
or camcorder
• If you have an S-VHS VCR or camcorder connected, you must
also connect a cable from the VCR's
TV's corresponding

VIDEO INPUT 1

cable.
Small picture does not have color
• The small picture will not have color if the large picture signal
does not have the color burst reference. All color signals and
some black-and-white signals are sent with color burst. Try
changing the channel of the big picture.
Black Box appears on the screen:
button to change
AUDIO STEREO/SAP
.
STEREO
function to wrong position.
CH 3/CH 4
switch on
TV/VCR
or connector and the
ANT A B
or jacks.
INPUT 1 2
cable
VIDEO
jack on TV.
jack to the

VIDEO OUT

jack in addition to the S-VHS
51