ProScan Monitor/Receiver Owner's Manual page 6

F i r s t - T i m e O p e r a t i o n
The steps below will help you get your TV connected and
working quickly. The page numbers on which you can find
detailed instructions for each of these steps are also listed
for your convenience.
1 Unpack TV and accessories.
The accessories that came packed with your TV include
two remote controls, six AAA batteries, power cord, and
antenna adapter.
VCR 2 • LD AUDIO
REW PLAY FF
REC STOP STOP PAUSE
CHAN
SKIP
DISPLAY
MUTE PREV CH CHAN
1 2 3
MENU
4 5 6
7 8 9
INPUT ANTENNA
0
•
CLEAR RESET
PIP SWAP
+
–
MOVE
MOVE PIP FREEZE
CC
2 Important Information: Optional Stand
A matching stand has been designed to be used with this
TV receiver. The recommended stand is provided with
hardware to secure the TV to the stand so that it cannot be
pulled off easily or tipped over. Your ProScan dealer can
help you choose the appropriate stand for your TV.
Stands are not available by mail order. To locate your
nearest P S dealer, call this toll-free number: 1-800-
RO CAN
PROSCAN.
Caution: If you choose not to use the recommended stand
for your TV receiver, take precautions that the stand or
other furniture on which the TV is placed is properly
located and of adequate strength to prevent the TV from
being tipped over accidently or pulled off the stand.
Tipping the TV over or pulling it off the stand could cause
both damage to the set and personal injury.
Incoming Cable
from Antenna or
Cable-TV System
3. Connect antenna or cable-TV system.
Most antenna or cable-TV systems can be connected as
shown here.
• Details for connecting a home antenna to your TV are on
page 38.
• Details for connecting a cable-TV system to your TV are
on pages 39-40.
• Details for connecting a VCR to your TV are on
pages 43-44.
2
Back of TV
CABLE/ANTENNA
ANT A
ANT B
CONVERTER
4 Attach power cord.
First attach the flat end of the power cord completely into
the connector on the back of your TV, and then plug the
other end into a wall outlet.
Be sure to insert the plug completely.
Back of TV Back of TV
Do This
5 Install batteries in remote control.
Details are on page 4.
6 Turn on TV, adjust the volume, and select a channel.
TV Button
VCR 2 • LD AUDIO
REW PLAY FF
REC STOP STOP PAUSE CHANNEL Buttons
DISPLAY SKIP
VOLUME Buttons
MUTE PREV CH
1 2 3
Number Buttons
4 5 6
7 8 9
INPUT ANTENNA
0
CLEAR • RESET
PIP SWAP
+
–
MOVE
MOVE PIP FREEZE
CC
1 To turn on the TV, press the
remote or press the
POWER
When using either remote, remember to point it at the
front of the TV.
2 Press the up or down button to adjust the
VOLUME
volume to a desired level.
3 Press the up or down button to select the next
CHANNEL
channel in memory. You can also press two number
buttons to select a channel. Channels 2-13 and 91 were
programmed into the channel memory at the factory, so
pressing up or down stops at these channels
CHANNEL
only. When you start the autoprogramming feature
(described next), your set will automatically scan
through all channels and place the active channels for
your area into its channel memory.
Back of TV
Not This
CHAN
CHAN
MENU
button on the master
TV
button on the simple remote.