11. Remove the drive sprocket guard; then remove the
two cap screws and retainer securing the drive
sprocket to the driveshaft. Remove the drive
sprocket.
NOTE: It may be necessary to loosen the drive
chain to remove the sprocket (see Periodic Mainte-
nance/Tune-Up - Drive Chain).
12. Remove the three through-bolts securing the engine
to the frame; then remove the left front mounting
bracket from the frame.
26
TR062A
TR041
13. Remove the engine/transmission assembly from the
frame tilting the rear of the assembly upwards and
lifting out the left side.
TR075A
Top-Side Components
NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
NOTE: The engine/transmission does not have to
removed from the frame for this procedure.
AT THIS POINT
KM414A
KM333A
KM325A