Arctic Cat 150 2014 Service Manual page 18

5. Remove the nut securing the driven pulley; then
remove the splined bushing, centrifugal clutch, pul-
ley, and V-belt.
INSTALLING
1. Using a rubber mallet, spread the driven pulley
sheaves by driving the V-belt down between the
sheaves; then slide the driven pulley and V-belt into
position.
2. Install the centrifugal clutch housing onto the driven
shaft; then install the splined bushing and secure
with the driven pulley retaining nut. Tighten to 43 ft-
lb.
16
KM276
3. Install the movable drive face onto the crankshaft
making sure to "bottom" the sheave out against the
center bushing. The crankshaft splines should be vis-
ible and the stepped washer should sit over the
splines.
If the splines are not protruding as shown, the V-belt
may be too deep in the drive sheaves. This would cause
KM262
the drive pulley to be under-tightened and severe drive
sheave or crankshaft damage could occur.
4. Secure the movable drive face to the crankshaft with
the drive pulley nut and tighten to 43 ft-lb.
5. Install the V-belt cover and tighten the cap screws
securely; then connect the cooling boots and tighten
the clamps securely.
6. Install the footwell assembly. Tighten all hardware
securely.
CAUTION
KM276
KM263A