Arctic Cat 150 2014 Service Manual page 21

3. Lift the handlebar out of the lower handlebar holders
and lay the handlebar forward.
4. Remove the cotter pins and slotted nuts securing the
tie rod ends to the steering post arm; then disconnect
the tie rods from the arm.
5. Remove the cotter pin and slotted nut from the lower
end of the steering post; then remove the upper steer-
ing shaft support block. Account for a cable guide,
two steering support blocks, and the upper steering
post bushing.
KM189A
6. Remove the steering post from the ATV.
CLEANING AND INSPECTING
1. Wash the tie rod ends in parts-cleaning solvent. Dry
with compressed air. Inspect the pivot area for wear.
Apply a low-temperature grease to the ends.
Always wear safety glasses when using compressed
air.
2. Inspect the tie rods for damaged threads or wear.
3. Inspect the tie rods for cracks or unusual bends.
4. Inspect all welded areas for cracks or deterioration.
5. Inspect the steering post and steering-post holders
for cracks, bends, or wear.
6. Inspect the handlebar clamps for cracks or wear.
KM590
7. Inspect the handlebar for cracks, wear, or unusual
bends.
8. Inspect the handlebar grips for damage or wear.
9. Inspect the lower steering post support bearing and
seal for wear or cracks.
INSTALLING
1. Apply a thin coat of grease to the lips of the lower
steering post seals; then lower the steering post into
position in the lower steering post bearings.
KM588
2. Apply a thin coat of grease to the upper steering post
bushing; then secure the steering post with the sup-
port blocks and existing hardware. Tighten to 15 ft-
lb.
! WARNING
KM589
KM593
19