Arctic Cat 150 2014 Service Manual page 83

9. Remove the A-arm.
CLEANING AND INSPECTING
1. Clean all A-arm components in parts-cleaning sol-
vent.
2. Clean the tie rod mounting hole of all residual Loc-
tite, grease, oil, or dirt for installing purposes.
3. Inspect the A-arm for bends, cracks, and worn bush-
ings.
4. Inspect the tie rod mounting holes for cracks or dam-
age.
5. Inspect the frame mounts for signs of damage or
wear.
INSTALLING
 NOTE: During installing, new cotter pins should be
installed.
1. Lubricate the A-arm bushings with grease; then
install the A-arm into the frame. Install the cap
screws and self-locking nuts. Tighten the nuts to 32
ft-lb.
MD2121
2. Secure the shock absorber to the A-arm with the cap
screw and self-locking nut. Tighten the nut to 29 ft-
lb.
Do not tighten the nut beyond the 29 ft-lb specification
or the shock eyelet or mount WILL be damaged.
MD2119
3. Lubricate the steering knuckle assembly with grease;
then install it into the A-arm and secure with the
flanged castle nut. Tighten the nut to 32 ft-lb; then
install a new cotter pin and the rubber spindle pin
boot.
4. Install the tie rod end into the steering knuckle and
secure it with the self-locking nut. Tighten the nut to
32 ft-lb; then install a new cotter pin.
CAUTION
MD2425
MD2424
MD2427
81