Arctic Cat 150 2014 Service Manual page 55

7. Install the CVT cooling ducts making sure to align
the notches in the boots with the location lugs.
Tighten the clamps securely.
8. Connect the AC generator plug; then install a cable
tie at marked location.
9. From the right-side, connect the shift rod to the
lower shift arm, then connect the starter lead and
install the spark plug cap.
10. Install the carburetor assembly and secure the intake
pipe to the cylinder with two nuts. Tighten securely.
TR063A
11. Install the air filter assembly; then connect the crank-
TR061A
case breather hose to the crankcase ventilator valve.
12. Install the gas tank (see Fuel/Lubrication/Cooling
TR072A
section); then install the left-side and right-side foot-
wells and side covers.
13. Connect the battery and install the seat.
14. Pour in the proper quantities of engine/transmission
oil; then start the engine and warm up to operating
temperature.
15. Check for leaks; then shut off engine and check lev-
els.
TR059A
TR058A
TR049
53