Arctic Cat 150 2014 Service Manual page 38

3. Inspect the drive pulley collar for wear or damage.
Measure the outside diameter of the drive pulley col-
lar sliding surface. The minimum service limit is
26.94 mm.
DRIVEN PULLEY/CENTRIFUGAL
CLUTCH ASSEMBLY
Disassembling
! WARNING
This procedure involves relaxing a compressed spring
assembly. DO NOT attempt disassembling without the
proper tools.
1. Place the driven pulley on a suitable spring compres-
sor; then mark the pulley faces and centrifugal clutch
for alignment during assembling.
2. Secure the centrifugal clutch with the spring com-
pressor; then remove the drive plate nut.
36
3. Release the spring pressure and remove the centrifu-
gal clutch assembly from the driven pulley.
4. Remove the spring and spring seat; then remove the
hub collar.
KM389
5. Remove four pins and bushings from the fixed face
hub; then remove the movable face.
KM374A
KM373
KM375
KM385
KM384
KM380