Transmission Lubricant; Drive Chain - Arctic Cat 150 2014 Service Manual

9. Inspect the area around the screen/filter cap for leaks.

Transmission Lubricant

Change the lubricant according to the Periodic Mainte-
nance Chart. When changing the lubricant, use approved
SAE 80W-90 hypoid gear lube.
To change the lubricant, use the following procedure.
1. Place the ATV on level ground.
2. Loosen the fill plug; then remove the transmission
drain plug and drain the transmission lubricant.
3. Install the drain plug and tighten to 21 ft-lb; then
remove the transmission level plug and the fill plug.
KM127A
4. Pour in the appropriate amount of recommended
lubricant into the fill hole while observing the level
hole. When correctly filled, transmission lubricant
should just be visible on the bottom threads of the
level hole.
5. Install the level plug and fill plug and tighten
securely; then check for leakage around the drain
plug.
Drive chain condition and adjustment should be
inspected each day before the ATV is operated. Always
follow the following guidelines for inspecting and servic-
ing the drive chain.
Failure to inspect and maintain the drive chain can be
hazardous. Operating the ATV with the drive chain in
poor condition or improperly adjusted can cause an
accident resulting in possible injury.
INSPECTING
Inspect the drive chain for any of the following condi-
tions.
A. Loose pins.
KM851A
B. Loose or cracked rollers.
C. Dry or rusted links.
D. Kinked or binding links.
E. Excessive wear.
The presence of any of the conditions requires drive
chain replacement.
 NOTE: If the drive chain is worn or damaged, the
sprockets may also be worn or damaged. Inspect the
sprockets for worn, broken, or damaged teeth.
Always inspect the sprockets when a new drive chain
is being installed.
KM845A
CLEANING AND LUBRICATING
The drive chain should be cleaned and lubricated fre-
quently to prolong chain and sprocket life. Use the fol-
lowing procedure to clean and lubricate the chain.

Drive Chain

! WARNING
TR028A
11