Arctic Cat 150 2014 Service Manual page 40

7. Measure the thickness of the centrifugal clutch shoe
lining. The minimum service limit for the lining is
2.0 mm.
 NOTE: If any shoe lining is below the service limit,
the complete set must be replaced.
Assembling
1. Place the fixed face of the driven pulley on the pulley
compressor base.
 NOTE: Make sure the spacer is on the base or dam-
age to the fixed face will occur when the spring is
compressed.
2. Apply multi-purpose grease to the O-rings and
grease seals on the movable face; then install on the
fixed face making sure the alignment marks are
properly aligned.
3. Install the pins and spacers into the fixed face hub;
then pack the cam slots in the movable face with
multi-purpose grease.
38
KM378
4. Install the spring seat over the hub and movable face
hub.
5. Place the spring holder on the spring; then install the
spring on the pulley assembly.
KX571
6. Place the centrifugal clutch assembly, drive plate nut,
and clutch compressor adapter in position; then using
the clutch compressor wing nut, compress the clutch
spring and install the nut (lightly coated with red
Loctite #271).
KM374A
KM384
KM385
KM386