Leading Edge Tilt Adjustment - Konica Minolta bizhub 160f Service Manual

6. Mechanical adjustment
6.2

Leading Edge Tilt Adjustment

1. Print the test pattern.
A
100 mm
100 mm
B
a
b
18
1382D007AA
1382U027AA
1382D008AA
1382U028AB
1382U029AA
Confidential – for internal use only, do not distribute
Field Service Ver. 1.0 Apr. 2005
2. Draw lines 100 mm (A and B) from
the center of the test pattern, as
shown in the illustration.
3. Load the test pattern into the Auto-
matic Document Feeder, and then
print five single-sided copies.
NOTE
• The test pattern should be posi-
tioned vertically.
4. Measure the lengths a and b on the
copies of the test pattern and, if
there is a large shift, adjust it accord-
ing to the following procedure.
Standard values of a and b = ? 1.0
mm
<If A is longer than B>
Using a coin, loosen the shoulder screw
shown in the illustration, and then slide
the scale on the Automatic Document
Feeder toward you.
NOTE
• After finishing the adjustment, be
sure to tighten the loosened shoul-
der screw.
<If A is shorter than B>
Using a coin, loosen the shoulder screw
shown in the illustration, and then slide
the scale on the Automatic Document
Feeder away from you.
NOTE
• After finishing the adjustment, be
sure to tighten the loosened shoul-
der screw.