Plate Nic Board (Nc-501) - Konica Minolta bizhub 160f Service Manual

2. Other
P402
P502
2.2.2

Plate NIC Board (NC-501)

A. Removal of the Plate NIC Board
4
1383U016AA
4980U039AC
4980U044AB
4980U043AB
Confidential – for internal use only, do not distribute
Field Service Ver. 1.0 Apr. 2005
5. Disconnect hookup connector P402
of the Network Interface Card.
6. Disconnect hookup connector P502
of the Plate NIC Board.
7. Remove the four screw, and the Net-
work Interface Card (unplug the
hookup connector provided on the
backside of the Network I/F Card).
1. Remove the Rear Right Cover. (2
screws)
2. Loosen one screw at the lower left
corner of the PWB mounting bracket
and remove the two fixing screws on
the right.
3. Slide out the PWB mounting bracket
in the direction of the arrow.
NOTE
Use the following precautions when
installing the PWB mounting bracket.
• Fit the upper left corner of the PWB
mounting bracket into the cutout in
the copier.
• When installing the PWB mounting
bracket in position, use care not to
allow the harness to be wedged in
mechanisms (shown inside a cir-
cle).