Transmission - Konica Minolta bizhub 160f Service Manual

Field Service Ver. 1.0 Apr. 2005
Code
0064 Did not detect any control channel signal in phase D within 60 seconds even though energy
still on the line.
0065 Did not detect any control channel signal within 60 seconds after detect silence in phase D.
0066 Did not receive T.30 signal or carrier signal after sending CFR in V.34.
0070 User presses stop key during receiving.
0071 Memory full during receiving.
23.2.2

Transmission

Code
0080 Did not detect any G3 signal within 35 sec. specified by ITU-T in phase B.
0081 Received DTC signal in transmission phase.
0082 Transmitting unit receives a signal other than DIS or DTC. and DCN in phase B.
0083 Detected FSK signal, but did not receive any signal within 35 seconds.
0084 Detect DCN signal in phase B.
0085 Transmitting unit sending DCS 3 times consecutively, but each time receiver responds with
DIS/DTC.
0086 Detected response signal other than DTC, DIS, FTT, DCN or CFR after sending DCS.
0087 Training attempt has failed because speed unit cannot adjust to low lower speed.
0088 Received DCN signal after sending out DCS signal.
0089 Remote side no mailbox function or not compatible.
008A Remote side not enough memory for relay initiate.
008B Receiver's protocol of DIS is received, but it is not compatible with our machine.
008C Remote side not enough memory for relay initiate.
008D Receiver's protocol of DIS is received, but remote side can't receive document temporary,
may be run out of paper or other reason.
008E Remote side CSI number not defined in machine one touch or speed dial directory.
008F Modem not ready to receive V.34 data during 6 seconds after receiving CFR signal.
0090 Called side document not ready for our polling.
0091 Sending out DCS+TCF signal 3 times consecutively but no signal in response from receiver.
0092 Remote side disconnected during transmitting phase.
0093 Received DCN signal after sending out DCS signal for V.34.
0094 It is over 4 minutes to TX a ECM block (64K).
0095 Wrong ID number when Polling RX or Mail Box TX.
0099 Remote side disconnect after primary channel.
009A Did not detect any signal after sending CI signal.
009C Received DCN after sending DTC in V.34 polling RX.
009D Remote side hang up before V.34 modem enters phase B state in V.34 polling RX.
009F Did not receive any response from other side after sending PPS_EOM signal.
00A0 User stops or cancels transmission job.
00A1 Document JAM during transmission.
00AE Did not finish V.8 procedure or detect V.21 signal after CM signal within 30 seconds.
00AF Modem can not enter into control channel after TX side sends out RCP signal for V.34.
00B0 Did not receive any command after our side retry three DCS signal in V.34 TX.
Confidential – for internal use only, do not distribute
23. FAX error (bizhub 160f/bizhub 161f only)
Possible Causes of Error.
Possible Causes of Error.
273