Table of Contents
Advertisement
Installation
Powering Up
Powering Down
28
Powering the cameras from a UPS ensures that the Multi-Media LT DVR can continue to
record video during a power outage, whether the outage is due to your utility or to a security
violation.
Figure 2-3
Plugging in a Multi-Media LT DVR
Connect power
supply from camera
to UPS
Connect power supply
from UPS to DVR
During the two minutes, or so, that the DVR needs to initialize, it is good practice to not turn
it off (see
Recovery, page 29).
Unit
1.
Plug the Multi-Media LT DVR and its cameras into a power source, preferably an
uninterruptible power supply (UPS).
2.
Turn on camera(s) and other hardware connected to the DVR.
3.
Press the power switch on the back panel of the Multi-Media LT DVR.
Note
Honeywell recommends that you power the cameras before powering the
Multi-Media LT DVR.
1.
Press the power switch on the back panel of the DVR.
2.
Unplug the Multi-Media LT DVR from the uninterruptible power supply (UPS) or wall
outlet.
Caution
The power cord is the disconnect device. Remove the appliance
coupler connector to disconnect the equipment.
VIDEO connector on
camera to VIDEO
INPUT on DVR
SPOT
MONITOR
1
2
3
4
5
6
VIDEO
INPUTS
TELCO
SERIAL PORT 2
LAN
SERIAL PORT 1
VGA
USB
USB
C OMMO N
CONTROL
SYS FAIL
OUTPUTS
SERIAL
SYS GOOD
1 G
2
G
3
G
4
G
PORT 3
FAULT
RELAY
7
8
28V, 3A
MAX
SERIAL
PORT 4
1 G
2
G
3
G
4
G
5 G
6
G
7
G
8
G
ALARM
INPUTS
IN
ON/OFF
OUT
115-230V~
50/60 Hz
NOT
5-3A
USED
POWER
Advertisement
Table of Contents
