Table of Contents
Advertisement
Audio
Monitoring and Recording Audio
Enabling Talking to a Site
Onsite Audio Using LocalView
Disabling Audio for LocalView
48
Caution
The Audio tab is unavailable on PCs without a sound card.
1.
Select the Enable checkboxes to enable transmission of sound from point to point
and to monitor it.
2.
Select the Record checkbox to record sound along with the video from the site.
Select the Talk (Audio Out) checkboxes, as needed for each channel (see
operator can broadcast on either or both channels, and to as many sites at once as can be
opened, that have audio.
Caution
Loud alarms can interfere with microphones or a speaker at times when
they could be needed most.
LocalView can be used to test or permanently monitor audio onsite.
1.
Using LocalView, on the Audio Setup tab, add a checkmark to the box for Channel 2
(Right) Used by Site Operator for Local Audio Monitoring. The channel 2 Enable,
Record and name are not needed for monitoring audio by a LocalView operator and
are removed from view. The Gain controls remain available for both audio channels.
2.
In the Channel 1 controls, add checkmarks to the Enable checkboxes for Talk, Listen
or both, as needed.
3.
Add checkmarks to the Record checkboxes for Talk, Listen or both, as needed. The
Enable checkbox needs to be selected before the Record checkbox can be.
Remove the check mark in the Channel 2 (Right) Used by Site Operator for Local Audio
Monitoring checkbox (see
4-3) to disable audio for LocalView.
Figure
4-3). An
Figure
Advertisement
Table of Contents
